Lighting and decorative columns model “zurigo”

Tender Specification

Special mast for decorative lighting made by a company ISO9001 certified and having authorisation as processing centre according to DM 14/01/08, brand “iPaliarredo” collection, series “Sport” model “ZURIGO”, height up to the lighting source ~ 15 - 20 - 25 meters above ground, namely composed of :

➔ Mast pyramd shaped with polygonal cross section, tilted on the vertical axis in 2 elements joined by forced overlapping, MAG approved by R.I.N.A. and I.I.S. (Istituto Italiano della Saldatura) and welding checking according to EN ISO 3834, subsequently smoothed by reducing the exceeding external metal for aesthetics reasons Brackets for floodlights support arranged on the longitudinal axis of the mast, with lighting fitting connection suitable to the luminaire to be installed. Provided for the anchorage to the basement by means of base plate and anchor bolts sunk into the foundation block, completed with works at base for the electric wiring according to the standard, slot for cable entry directly from the bottom plate, earth connection, reinforced opening and inspection door

Protection against corrosion by means of hot dip galvanization obtained with the following cycle: degreasing; pickling, washing, fluxing, pre heating; hot dip galvanization in melted zinc bath at 440÷450°, with minimum percentage of zinc into the bath ≥ 98.5%.

Coating obtained according to UNI EN ISO 1461 with minimum thickness 55 microns et average 70 microns.

External painting, if any, with colour from our colour card, rough effect, obtained with thermosetting powders cycle including: cleaning from zinc coating burs; smoothing of the surfaces by means of a light mechanic device; cleaning of the surfaces in order to eliminate grease or dirty and create a good adherence base; application by means of electrostatic spray of polyester powder suitable for galvanized surfaces for outside installation, in order to reach 60/80 micron thickness; polymerization into oven at constant temperature of approx. 200° for 40-50 minutes, package for each column, by banding with tissue 100% polyester, (no pluriball), in order to avoid damages during the handling phase. The characteristics of the obtained coat will be: average thickness 60 micron, resistance to checkering test ISO2409, resistance to crash test to UNI8901

The design of the structure and the verification of the resisting sections will be carried out according to the standard in force and verification report signed by a registered engineer

Document owned by Pali Campion srl. Reproduction is permitted only if the source is cited. Technical data are indicative; final specifications will be stated when ordering.